USER GUIDE - TECHNICAL ICE AXE

Only individuals who are trained in mountaineering and climbing techniques or who are under direct and continuous visual supervision by someone trained in these techniques are authorised to use this equipment. Do not use this equipment without prior training or if you feel at all uncertain. You are also responsible for taking note of the updates concerning your equipment. It is not possible to list all possible incorrect uses of this product. Generally speaking, any uses which differ from those described in this notice are prohibited. Failure to respect any of the warnings may result in serious injury or death.

Simond ice axes are items of Personal Protective Equipment that act as a falls from height prevention measure covered by EU Regulation 2016/425. Anaconda and Mamba ice axes are technical mountaineering and ice climbing axes (type 2 ice axe). They are designed for mountaineering, ice climbing and mixed climbing. In the context of intensive use in mixed climbing (for example in dry tooling), we recommend that you always check the condition of the tool before and after each trip out. Equip your ice axe with a head guard and a tip protector for transport. 

Before, during and after use, check that the equipment is in good order:
- Check the condition and tightening of the pick assembly screws.
- Check that there are no cracks, sharp edges, distortions, corrosion, rust, wear or any other damage.
- Check the condition of the rivets.
- Check that the markings on the product are legibleIf you’re have any doubts about the condition of your equipment, or if your product has a defect, destroy it to ensure that it is not used again.
A more detailed inspection should be carried out at least once a year by a qualified person. After a serious fall, your product and all other equipment in the belay system must be withdrawn from service. The safety of the user depends on maintaining the product’s effectiveness and strength.

Your product must be cleaned with clean water then dried with a cloth to remove all traces of humidity. When it has been in contact with seawater or a marine environment, rinse and air-dry your equipment. Rub the metal parts with an oiled cloth, to prevent corrosion on the bare parts of the metal. Wipe off any excess oil, especially from the plastic parts. Store your product in a dry, cool, well-ventilated place, away from light and any heat sources. Long-term storage of your equipment in bad conditions may make it unuseable. Avoid any contact with chemical products (acids, bleach, petrol, diesel, solvents, etc.) which may damage the product’s resistance. The original packaging must be used during transportation. Any repair or modification to the product is strictly prohibited. 

The maximum life of Simond products is issued based on the manufacturing date indicated on the product:
-10 years for products prone to ageing (fabric and plastic);
-Lifetime for metal products and parts
The genuine life span of your SIMOND product depends on the frequency and usage methods specific to each user. It may only last for one outing should the product fall, be overloaded, or get stuck or twisted, if used intensively or in demanding circumstances (to halt a fall, or in the event of exposure to hazardous chemicals and extreme temperatures, etc.). As long as your product meets the checking requirements described in the INSPECTING paragraph, there is no need to withdraw it from use. If you have any queries on the status of the product, have a competent and trained person check it or destroy it.

This SIMOND product is guaranteed for 2 years against any type of manufacturing defect, from the date of purchase. Excluded from the warranty are normal wear and tear as well as any damage resulting from improper use or modification of the product, improper storage or improper maintenance.